![]() ![]() Installing IPFire NOTE: Before starting take note of the MAC Address of both your NICs. As stated before if you are using Hyper-V you must download the i586 version. The only major consideration, in my case, and because I’m installing in a Hyper-V virtual machine, is that the x86_圆4 version of IPFire is not yet compatible with Hyper-V (or vice-versa), so I’ll be using the i586 version of it.ĭownload IPFire from. I’m installing in Hyper-V but it is exactly the same process if you’re installing IPFire on a physical machine.įor further hardware requirements, consult them here. You will need a machine with two network cards, one for the internet side, which will be the “Red” interface and one for the LAN side, which will be the “Green” interface. ![]() ![]() If you’d like to know how to achieve the same goal with a Raspberry Pi, stay tuned as I will soon be writing an article on how to transform your Raspberry Pi into a NAT router. In this article I will be describing how to install IPFire, a fairly easy to install and configure Linux firewall that also acts as a NAT router.įor the purpose of this article, I’ll be focusing on installing and basic setup. There are many ways and solutions to route network traffic between your LAN and the Internet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |